How You Can Mount Deer Velvet Antlers

Mounting deer antlers with velvet is a method of using antlers from a deer hunt in order to utilize all parts of the animal. Deer antler mounts are conventional decorations in hunting cabins as well as lodges and mounting your antler with velvet will give you the opportunity to remember your beloved hunting expedition.

In preparing for the process, the antlers should be positioned over the foam form provided in the mounting kit so that you will get an idea of where to center the antlers on the form. Holes should be drilled between them on the skull plate making use of a 1/8" drill bit and drill. The holes should then be countersunk with a 1/4 "drill bit in order for the heads of the screws drilled into the antlers to flush with the skull plate.

Furthermore, the antler should be placed on the foam form and one screw should be drilled through the horns as well as the form so that the antlers can be held in place and the antlers should not be screwed tightly. The skull plate top flush should then be aligned with the form as much as possible while a gap should be left between the antlers and the bottom of the foam form. Subsequently, they should be pushed into clay and centered on the form. The second screw should be drilled into the antlers through the clay and foam form while the first screw should then be tightened down.

The papier mache that came with the kit should be mixed with a small amount of water and stirred with the popsicle stick from the kit. The gaps should be covered with the papier mache and smoothened out with the popsicle stick to prevent rough edges. The papier mache should be allowed to dry for about one hour after which a piece of fine grit sandpaper should be used to sand down any excess ridges.

Thereafter, the square piece of the velvet should be laid over the antlers and foam form, and it should be centered. The velvet should be stapled to the back of the form with the aid of a staple gun. You should then drill holes from the back of the wooden mounting plaque by the means of the back of the form. The mounting screws should then be screwed in from the back of the plaque, sticking the antlers and the foam form securely to the plaque.

Article Source: http://EzineArticles.com/?expert=Shola_George_Otenaike

Article Source: http://EzineArticles.com/7999969